- Heading to Data Center Network Application, SURTEC has developed Angled Patch Panels for more convenient and efficient cable management. Without horizontal cable managements needed, the patch cords at the front side and cables at the rear side can be easily guided into the vertical racks. With development of Angled FJack or EJack to be inserted into a snap-in panel, a more convenient installation way to use Snap-in Angled Panel has been invented.
Please contact with your SURTEC Sales Representative for detailed product information. If you’re new on board, please kindly use contact us and we will serve your inquiries efficiently.
-
● PRODUCT PERFORMANCE
- ISDN Voice Application (Only Snap-in Panel with Angled Jack available)
- Category 5e Data Application (Connecting Hardware)
- Category 6 Data Application (Short-Link 15M/Connecting Hardware)
- Category 6A Data Application (Only Snap-in Panel with Angled Jack available, Angled Jack under Development)
- UL / cUL 1863 LISTED
- UTP Available for PCB Type and Snap-In Type
- FTP Available for Snap-In Type
- PCB Type, Keystone Type Available
- All Contacts used with 50μ” Gold Plated
- Customization Available (Silkscreen, Icons, etc)
- TIA/EIA 568B.2, ISO/IEC 11801 2nd EDITION: 2002 for Cat.5e
- TIA/EIA 568B.2-1, ISO/IEC 11801 2nd EDITION: 2002 for Cat.6
- TIA/EIA 568B.2-10, ISO/IEC 11801: 2002 AMENDMENT 2 for Cat.6A
- FCC Part68 (TIA-1096)
Please contact with your SURTEC Sales Representative for detailed product information. If you’re new on board, please kindly use contact us and we will serve your inquiries efficiently.
SURTEC Angled Patch Panel
